Using your Anodyne Therapy Home System (Model 120)

Before using your Home System, please read the following:

For additional safety information and instructions on using your Anodyne Therapy Home System Model 120, please download the Procedure Manual:

120 Patient Home System Procedure Manual

Setting up your Anodyne Therapy Home System

• Place the control box on the floor or on a table next to you.  Be sure there is an electrical outlet close by.

• Plug the AC Adapter into an active electrical outlet.

• Turn on the Main Control Unit by flipping the On/Off Switch on the back of the unit.  Both green indicator lights will turn on (if not, please see the Troubleshooting section of the Procedure Manual).  You Anodyne Therapy Home System is now ready to use.

For instructions on using the Soft Shoe Application System, please refer to the Procedure Manual.

Instructions for Use for Treatment of Peripheral Neuropathy

Placement:  Place two pads in the form of a "T" inside the Soft Shoe.  If pain or poor circulation exists in legs, place one pad on each side of the calf using the Leg Attachment Strap.  *Do not wrap the Leg Attachment Strap too tightly.*

Initial Frequency:  Daily for 3 months

Maintenance Frequency:  1-3 times per week after initial 90 day period.

Treatment Time:  30 minutes - check treated area every 10 minutes for burns.

For protocols for treating other conditions using your Anodyne Therapy Home System Model 120, please refer to the Procedure Manual.